CWE-787
The NXP ENET-QOS Ethernet driver's receive work handler eth_nxp_enet_qos_rx() in drivers/ethernet/eth_nxp_enet_qos hands each processed descriptor back to the DMA by writing desc->read.control = rx_desc_refresh_flags, which sets OWN_FLAG and BUF1_ADDR_VALID_FLAG. RDES0 of a receive descriptor is the DMA buffer address in read format, but the hardware write-back aliases that word with the VLAN tag fields (or, for a context descriptor, the timestamp low word), so it is destroyed on every completion. The success path rewrites desc->read.buf1_addr before re-arming; the four drop paths — errored or non-first descriptor, net_pkt_rx_alloc() failure, invalid descriptor length, and net_pkt_get_frag() failure — did not, re-arming the ring slot with the write-back residue as its DMA target address. The drop paths are driven entirely by received traffic and need no privilege or special configuration. With the defaults for this driver (CONFIG_NET_BUF_DATA_SIZE of 128 and 16 receive descriptors) a single full-size frame consumes twelve ring slots and twelve K_NO_WAIT fragment allocations, so a short burst of frames sent to the device exhausts the receive pools and reaches the allocation-failure paths; a frame with a receive error, or any frame whose first descriptor was already dropped, reaches the non-first-descriptor path. Once a slot has been poisoned, the DMA writes the next frame received in that slot to an address derived from the frame's VLAN tag fields rather than to a receive buffer. On the supported MCX SoCs that address falls in flash or reserved space, so the transfer raises a fatal bus error that the driver only logs — there is no reset or recovery path — and reception stops permanently until the device is rebooted; where the write is silently discarded instead, the untouched buffer is later handed to the network stack with a length, delivering stale buffer contents as if they were a received frame. A single triggering event is enough to make the condition persistent, so an attacker able to send traffic to the device can permanently disable its network interface.
━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
CVE-2026-90591
CVSS 7.5/10 · YÜKSEK · 09.11.2026
CWE: CWE-787
Vector: CVSS:3.1/AV:N/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:H
━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
🎯 AÇIK NEDİR?
Buffer Overflow / Memory Corruption
Açıklama: The NXP ENET-QOS Ethernet driver's receive work handler eth_nxp_enet_qos_rx() in drivers/ethernet/eth_nxp_enet_qos hands each processed descriptor back to the DMA by writing desc->read.control = rx_desc_refresh_flags, which sets OWN_FLAG and BUF1_ADDR_VALID_FLAG. RDES0 of a receive descriptor is the DMA buffer address in read format, but the hardware write-back aliases that word with the VLAN t…
⚡ SALDIRI ZİNCİRİ
Saldırı adımları:
1. Fuzzing ile çöküş noktası tespit edilir: Boofuzz, AFL++ ile.
2. GDB/PEDA ile offset hesaplanır: pattern create 500 → crash → pattern offset EIP_VALUE
3. Stack/Heap layout analizi.
4. ROP gadget ile NX bypass.
5. Metasploit varsa: use exploit/... ; run
🔧 Araçlar: GDB+PEDA/pwndbg, ROPgadget, pwntools, Metasploit, AFL++
🗺️ MITRE ATT&CK: T1203 (Exploitation for Client Execution), T1068
🌍 GERÇEK DÜNYA ETKİSİ
Hizmet tamamen devre dışı bırakılabilir.
🛡️ ÇÖZÜM VE MİTİGASYON
→ Üretici tarafından yayınlanan yamayı uygula.
→ ASLR/NX/Stack Canary aktif olduğunu kontrol et.
→ Yama öncesi: servis erişimini VPN arkasına al veya IP whitelist uygula.
→ WAF kuralı ekle, anormal trafik için IDS alert oluştur.
⚠️ ACİLİYET
⚠️ Bu hafta (7 gün) — Yüksek risk, anonim uzaktan.
────────────────────────────────────────
[Kural Tabanlı Analiz] [💡 config.json dosyasına ai_key (Claude: sk-ant-... veya Groq: gsk_...) ekleyerek gerçek AI analizi kullanabilirsiniz]
[⚠️ AI key mevcut ancak istek başarısız — kural tabanlı analiz kullanıldı]