BELİRSİZ Güvenlik Açığı
In the Linux kernel, the following vulnerability has been resolved: nfsd: reject out-of-range nseconds in NFSv3 SETATTR and create ops A client can send an NFSv3 SETATTR, CREATE, MKDIR, SYMLINK or MKNOD carrying an atime or mtime whose nseconds field is out of range. The value is well-formed on the wire and decodes cleanly into a valid uint32, but it is not a valid timespec64: tv_nsec must be less than NSEC_PER_SEC. Nothing in the setattr path clamps it. notify_change() runs the time through timestamp_truncate(), which does not reduce tv_nsec below NSEC_PER_SEC when the filesystem supports nanosecond granularity (s_time_gran == 1), and the inode atime/mtime setters store it verbatim (only ctime is normalized, via inode_set_ctime_to_ts()). The un-normalized value then corrupts on-disk metadata: ext4's ext4_encode_extra_time() shifts tv_nsec left by EXT4_EPOCH_BITS, which overflows the 32-bit extra field and clobbers the seconds-epoch bits, so the stored seconds (and thus the year) are wrong on read-back. XFS with bigtime mis-stores the timestamp for the same reason. Validate the client-supplied atime/mtime in the proc handlers and return NFS3ERR_INVAL before anything is changed. RFC 1813 lists NFS3ERR_INVAL for SETATTR and describes it as the error for a value the server 'can not store ... in its own representation'; the client maps it to EINVAL. Checking in the proc handlers, rather than in nfsd_setattr(), keeps the rejection in front of object creation. The create operations create the object before nfsd_create_setattr() runs, so a late failure would leave the new object behind and turn a non-idempotent request into a namespace change that reports failure. The check is therefore done up front, for the create operations before the object is created. tv_nsec is a long, so the comparison casts it to unsigned long (the same width) rather than to u32, matching timespec64_valid(). A u32 cast would truncate on 64-bit; the unsigned long cast also rejects a value that became negative when an out-of-range u32 wire nseconds was assigned to a 32-bit long. Only client-supplied times are checked: SET_TO_SERVER_TIME requests carry no client value. The sattrguard3 ctime is deliberately left alone: an out-of-range guard simply never matches the object's ctime and yields NFS3ERR_NOT_SYNC via the existing guardtime comparison, which is the protocol-correct outcome rather than rejecting the request.
━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
CVE-2026-89666
CVSS 0/10 · BELİRSİZ · 11.09.2026
━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
🎯 AÇIK NEDİR?
Açıklama: In the Linux kernel, the following vulnerability has been resolved:
nfsd: reject out-of-range nseconds in NFSv3 SETATTR and create ops
A client can send an NFSv3 SETATTR, CREATE, MKDIR, SYMLINK or MKNOD
carrying an atime or mtime whose nseconds field is out of range. The
value is well-formed on the wire and decodes cleanly into a valid
uint32, but it is not a valid timespec64: tv_nsec must be…
⚡ SALDIRI ZİNCİRİ
CVSS vektörü mevcut değil. Üretici dokümanını inceleyin.
🌍 GERÇEK DÜNYA ETKİSİ
🛡️ ÇÖZÜM VE MİTİGASYON
→ Üretici tarafından yayınlanan yamayı uygula.
→ WAF kuralı ekle, anormal trafik için IDS alert oluştur.
⚠️ ACİLİYET
📌 Düşük öncelik — rutin güncelleme yeterli.
────────────────────────────────────────
[Kural Tabanlı Analiz] [💡 config.json dosyasına ai_key (Claude: sk-ant-... veya Groq: gsk_...) ekleyerek gerçek AI analizi kullanabilirsiniz]
[⚠️ AI key mevcut ancak istek başarısız — kural tabanlı analiz kullanıldı]