CVE Professor — Güvenlik Açığı Takip & Analiz
›
CVE-2026-80712

YÜKSEK Güvenlik Açığı

YÜKSEK CVSS 8.4 ⚡ EPSS 0.2% NVD

In the Linux kernel, the following vulnerability has been resolved: spi: spi-qpic-snand: write the feature value before executing SET_FEATURE qcom_spi_send_cmdaddr() programs NAND_FLASH_CMD/NAND_EXEC_CMD and submits the descriptors, which makes the controller execute the command immediately. For SPINAND_SET_FEATURE the value to be written is only placed into NAND_FLASH_FEATURES afterwards, by qcom_spi_io_op(), in a second submission - so the chip is programmed with whatever that register happened to hold from a previous operation, and the intended value is only applied by the *next* SET_FEATURE. Measured on a TP-Link Archer AX55 v1 (IPQ5018, ESMT F50L1G41LB): writing 0x40 to the configuration register (0xb0) leaves the chip at 0x00, and the subsequent write of 0x00 leaves it at 0x40 - every write lands one operation late. This stayed unnoticed until v6.18 added SPI-NAND OTP support together with OTP entries for ESMT chips. spinand_otp_rw() enables OTP mode, reads, and disables it again, and mtd_otp_nvmem_add() does this during MTD registration. With the off-by-one, the "disable" write actually applies the previously requested value, so CFG_OTP_ENABLE ends up set: the chip stays in OTP mode, every subsequent array read returns the OTP area instead of the array (UBI reports an empty device) and all writes fail with -EIO because the OTP area is write protected. On this board that makes the whole flash unusable and the device unbootable. Write the feature value into NAND_FLASH_FEATURES as part of the same transaction, before NAND_EXEC_CMD. While at it, copy only the bytes the operation actually carries - the previous code dereferenced a 4-byte pointer on a one-byte buffer (spinand->scratchbuf). With this patch the flash contents read back bit-identical to a known-good dump of the same board taken under the vendor firmware (md5-verified across partitions), and writes work.

Yayınlanma 28.08.2026
ISO Tarih 2026-08-28
CVSS Sürüm v3.1
Kaynak NVD
CVSS v3.1 Metrikleri
CVSS:3.1/AV:L/AC:L/PR:N/UI:N/S:U/C:H/I:H/A:H
Attack Vector Local AV:L
Attack Complexity Low AC:L
Privileges Req. None PR:N
User Interaction None UI:N
Scope Unchanged S:U
Confidentiality High C:H
Integrity High I:H
Availability High A:H
EPSS — Exploit Olasılık Skoru
0.2%
30 günlük olasılık
Tüm CVElerin 9. yüzdeliğinde — Bu açığın istismar edilme ihtimali çoğu CVEden yüksek.
AI Güvenlik Analizi

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
CVE-2026-80712
CVSS 8.4/10 · YÜKSEK · 28.08.2026
Vector: CVSS:3.1/AV:L/AC:L/PR:N/UI:N/S:U/C:H/I:H/A:H
━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

🎯 AÇIK NEDİR?
Açıklama: In the Linux kernel, the following vulnerability has been resolved:

spi: spi-qpic-snand: write the feature value before executing SET_FEATURE

qcom_spi_send_cmdaddr() programs NAND_FLASH_CMD/NAND_EXEC_CMD and submits
the descriptors, which makes the controller execute the command
immediately. For SPINAND_SET_FEATURE the value to be written is only
placed into NAND_FLASH_FEATURES afterwards, by…

⚡ SALDIRI ZİNCİRİ
Yerel/fiziksel erişim | kimlik doğrulama GEREKMİYOR | kullanıcı etkileşimi YOK | düşük karmaşıklık.

🌍 GERÇEK DÜNYA ETKİSİ
Tüm gizli veriler okunabilir/çalınabilir; sistem verileri değiştirilebilir/silinebilir; hizmet tamamen devre dışı bırakılabilir.

🛡️ ÇÖZÜM VE MİTİGASYON
→ Üretici tarafından yayınlanan yamayı uygula.
→ WAF kuralı ekle, anormal trafik için IDS alert oluştur.

⚠️ ACİLİYET
⚠️ Planlı bakım (2 hafta) — Yüksek seviye.

────────────────────────────────────────
[Kural Tabanlı Analiz] [💡 config.json dosyasına ai_key (Claude: sk-ant-... veya Groq: gsk_...) ekleyerek gerçek AI analizi kullanabilirsiniz]

[⚠️ AI key mevcut ancak istek başarısız — kural tabanlı analiz kullanıldı]

Hedef Keşif Sorguları

FOFA Sorgusu

app="TP-LINK Router"
CVSS Skoru
8.4 / 10 · CVSS YÜKSEK