CWE-787
The CC1200 sub-GHz IEEE 802.15.4 driver takes the PHY packet length from the first byte of the radio's RX FIFO in get_packet_length() and validates it in verify_rxfifo_validity() (drivers/ieee802154/ieee802154_cc1200.c). That validation only enforced a lower bound (pkt_len < 3); its second clause rejects a FIFO that holds more bytes than declared and therefore never bounds large values. Because the driver configures the radio for variable packet length with PKT_LEN = 0xFF, the length byte is an over-the-air value of 0-255 that reached net_pkt_rx_alloc_with_buffer() and the subsequent SPI burst read unclamped. An unauthenticated attacker within radio range can transmit a frame that presents a length byte above the IEEE 802.15.4 maximum of 127 while the chip's 128-byte RX FIFO has not overflowed, so the driver's RX_FIFO_ERROR pre-check does not fire. Reaching this state depends on RF framing and timing, since the RX thread is driven off the PKT_SYNC_RXTX signal and may sample the FIFO before a packet is complete; no pairing, authentication, or user interaction is required. With the default CONFIG_NET_BUF_FIXED_DATA_SIZE and CONFIG_NET_BUF_DATA_SIZE=128, an allocation larger than one fragment is satisfied by a chain of fragments, but read_rxfifo_content() performs a single SPI burst of pkt_len bytes into the first fragment's buf->data and then calls net_buf_add() with the same length. A length above 128 therefore writes up to 127 bytes past the end of a fragment in the contiguous rx_bufs pool and leaves a net_buf whose len exceeds its capacity. The overflowing bytes are FIFO-underflow output rather than attacker-chosen data, so the practical impact is network-buffer-pool corruption and crashes rather than a controlled write. Only builds that enable CONFIG_IEEE802154_CC1200 with an attached CC1200 radio are affected.
━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
CVE-2026-75084
CVSS 6.8/10 · ORTA · 14.10.2026
CWE: CWE-787
Vector: CVSS:3.1/AV:A/AC:H/PR:N/UI:N/S:U/C:N/I:H/A:H
━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
🎯 AÇIK NEDİR?
Buffer Overflow / Memory Corruption
Açıklama: The CC1200 sub-GHz IEEE 802.15.4 driver takes the PHY packet length from the first byte of the radio's RX FIFO in get_packet_length() and validates it in verify_rxfifo_validity() (drivers/ieee802154/ieee802154_cc1200.c). That validation only enforced a lower bound (pkt_len < 3); its second clause rejects a FIFO that holds more bytes than declared and therefore never bounds large values. Because…
⚡ SALDIRI ZİNCİRİ
Saldırı adımları:
1. Fuzzing ile çöküş noktası tespit edilir: Boofuzz, AFL++ ile.
2. GDB/PEDA ile offset hesaplanır: pattern create 500 → crash → pattern offset EIP_VALUE
3. Stack/Heap layout analizi.
4. ROP gadget ile NX bypass.
5. Metasploit varsa: use exploit/... ; run
🔧 Araçlar: GDB+PEDA/pwndbg, ROPgadget, pwntools, Metasploit, AFL++
🗺️ MITRE ATT&CK: T1203 (Exploitation for Client Execution), T1068
🌍 GERÇEK DÜNYA ETKİSİ
Tüm gizli veriler okunabilir/çalınabilir; sistem verileri değiştirilebilir/silinebilir; hizmet tamamen devre dışı bırakılabilir.
🛡️ ÇÖZÜM VE MİTİGASYON
→ Üretici tarafından yayınlanan yamayı uygula.
→ ASLR/NX/Stack Canary aktif olduğunu kontrol et.
→ WAF kuralı ekle, anormal trafik için IDS alert oluştur.
⚠️ ACİLİYET
📋 Rutin güncelleme (30 gün)
────────────────────────────────────────
[Kural Tabanlı Analiz] [💡 config.json dosyasına ai_key (Claude: sk-ant-... veya Groq: gsk_...) ekleyerek gerçek AI analizi kullanabilirsiniz]
[⚠️ AI key mevcut ancak istek başarısız — kural tabanlı analiz kullanıldı]